Pack : 20kg
Colour : Grey
Hir Bond 009
hir bond 009 is ideal for fixing vitrified tiles and small sized marble on wall. Surface should be prepared before applying adhesive. no paints, wall putty or damaged wall surface for bonding and adhesion.
|Parameter||FixoBond||FixoBond +||FixoBond Prime|
|Appearance||Grey free flow powder||Grey free flow powder||White free flow powder|
|Pot Life||60 minutes||60 minutes||60 minutes|
|Required Water Ratio||21 to 23 %||27 to 29 %||27 to 29 %|
|Coverage @ 3 mm||2.30 sqft/Kg||2.30 sqft/Kg||2.30 sqft/Kg|
|Coverage @ 6 mm||1.15 sqft/Kg||1.15 sqft/Kg||1.15 sqft/Kg|
|Coverage @ 9 mm||0.75 sqft/Kg||0.75 sqft/Kg||0.75 sqft/Kg|
|Bulk Density||1600 - 1900 Kg/m3||1600 - 1900 Kg/m3||1600 - 1900 Kg/m3|
|Maximum Aggregate Size||1 mm||1 mm||1 mm|
As Per IS-15477
HIR Bond 009
|Dry Condition||-||900 N|
|Wet Condition||-||600 N|
|Dry Condition (24 Hrs.)||4.00 KN||4.75 KN|
|Dry Condition (14 Days)||10.00 KN||11.00 KN|
|Heat Aging Condition||5.00 KN||6.00 KN|
|Wet Condition||5.00 KN||6.75 KN|
|Open Time||-||20 Minutes|
|Adjustment Time||-||20 Minutes|
|Foot Traffic||-||24 Hours|
# The Values obtained are from our laboratory testing conditions. Tests conducted on site conditions may show slight variation due to methods of testing/application.
PREPARATION AND APPLICATION
Floor Base Preparation
Floor Surface where tile has to be fixed should be of concrete base, properly cured, leveled and free of cracks.
Wall Base Preparation
Wall Surface where tile has to be fixed should be of concrete base, properly cured, leveled and free of cracks.
Clean surface by wire brush and ensure contamination-free area.
Mixing Tile Adhesive
Pour Hir Tile Adhesive into water as per required ratio.
Mix the paste using hand mixer for 5 minutes.
Rest for 5-10 min and remix again for 2-3 min.
Floor Wet the surface and tile before application.
Wall Wet the surface and tile before application.
Apply adhesive on the wall/floor using trowel at a thickness of 3-6 mm and comb with notch trowel. Do not spread more than 1 sq. m of area at a time.
Fix tiles firmly into position with a sliding motion and hammer with soft mallet to ensure a better bond.
Clean off excessive adhesive between the joints and on tiles with a damp cloth.
Leave To Dry
Do not disturb the tiling for minimum 24 hours.