Pack : 20 + 5 = 25Kg
Colour : Grey / White
Hir High Bond Grey/White (+)
Hir high bond grey/white-2part is formulated especially keeping consideration of increasing size of tiles and reducing thickness. Architects are opting for newest trend of design and sizes, so we have also improved higher end tiles adhesive which adheres fast and flexible to bear impact and vibrations. This system consists of 2 part cement and emulsion to enhance the bonding and flexibility of product.
|Parameter||Hir High Bond Grey/White(+)|
|Appearance||Grey free flow powder|
|Pot Life||60 minutes|
|Required Water Ratio||27 to 29 %|
|Coverage @ 3 mm||2.30 sqft/Kg|
|Coverage @ 6 mm||1.15 sqft/Kg|
|Coverage @ 9 mm||0.75 sqft/Kg|
|Bulk Density||1600 - 1900 Kg/m3|
|Maximum Aggregate Size||1 mm|
As Per IS-15477
Type - I
As Per IS-15477
|Dry Condition||750 N||-||850 N||900 N||900 N|
|Wet Condition||450 N||-||500 N||580 N||600 N|
|Dry Condition (24 Hrs.)||2.50 KN||4.00 KN||2.65 KN||4.50 KN||4.75 KN|
|Dry Condition (14 Days)||8.00 KN||10.00 KN||8.25 KN||10.50 KN||11.00 KN|
|Heat Aging Condition||4.00 KN||5.00 KN||4.05 KN||5.15 KN||6.00 KN|
|Wet Condition||4.00 KN||5.00 KN||4.50 KN||5.50 KN||6.75 KN|
|Open Time||-||-||10 Minutes||20 Minutes||20 Minutes|
|Adjustment Time||-||-||5 Minutes||15 Minutes||20 Minutes|
|Foot Traffic||-||-||24 Hours||24 Hours||24 Hours|
# The Values obtained are from our laboratory testing conditions. Tests conducted on site conditions may show slight variation due to methods of testing/application.
PREPARATION AND APPLICATION
Floor Base Preparation
Floor Surface where tile has to be fixed should be of concrete base, properly cured, leveled and free of cracks.
Wall Base Preparation
Wall Surface where tile has to be fixed should be of concrete base, properly cured, leveled and free of cracks.
Clean surface by wire brush and ensure contamination-free area.
Mixing Tile Adhesive
Pour Hir Tile Adhesive into water as per required ratio.
Mix the paste using hand mixer for 5 minutes.
Rest for 5-10 min and remix again for 2-3 min.
Floor Wet the surface and tile before application.
Wall Wet the surface and tile before application.
Apply adhesive on the wall/floor using trowel at a thickness of 3-6 mm and comb with notch trowel. Do not spread more than 1 sq. m of area at a time.
Fix tiles firmly into position with a sliding motion and hammer with soft mallet to ensure a better bond.
Clean off excessive adhesive between the joints and on tiles with a damp cloth.
Leave To Dry
Do not disturb the tiling for minimum 24 hours.