Hir Electro Static Dissipative Flooring-9997

  • Home
  • Hir Electro Static Dissipative Flooring-9997

Hir Electro Static Dissipative Flooring-9997

Introduction Of Floor Coat

The flooring is the most abusive part of any Industrial, Commercial or Institutional Building exposing to both physical and chemical abuses like the presence of dust, continuous equipment traffic, oil and chemical spillages from occasional to continuous immersion leading to degradation of floor surfaces.

HIR FLOOR COAT Screeds & Toppings Offers seamless high performance flooring system with high chemical, bacterial and abrasion resistance to enhance floor design life. The ultimate convenience of ease to clean surface with increased resistance to liquid penetration. The toughness and durability of the hygienic coating along with choice of attractive colors suits to variety of environmental conditions. The coated decorative surface presents ideal and pleasant working atmosphere. Hir Floor Coat has wide options of underlayment, screed mortars and floor toppings. The comprehensive range covers - cementitious underlayment, coving, floor marking, re-lay/ over-lay coatings, epoxy and polyurethane based mortars and floor toppings, anti static ESD conductive floor toppings, EPU toppings, PU coatings, slip resistant and chemical resistant toppings and silicate floor coatings.

Application

 
 

Surface Preparation

Prepare floor surface either mechanically by grinding / shot blasting / scarifying or manually by using wire brush. Floor should be made structurally sound, clean and free from loose particles, oil, grease or any other contaminants.
If any cement laitance, loose particles, mould release agent, curing compound and any other contaminants found in the floor should be removed
Vacuum cleaning should be done after above treatments.
The maximum moisture content of the substrate should be less than 5 when checking with moisture meter.
Irregularities / Undulations in floor to be filled with epoxy based mortar Hir Floor Coat SEMS / Hir Floor Coat EMS as underlayment to level floor surface.
Existing expansion joints in the floor should be continued through the surface of leveling layer.
The application area should be kept dust free. All the opening in the room should be temporarily covered with polythene sheets & masking tape.
 
 
Download Brochure